Where do you put starter fluid on a jet ski?

How do you prime a jet ski?

to prime your fuel system after removing fuel lines you need to:

  1. pull your return fuel line off your carb, it will be hooked to the top barb on your carb (bottom is input, top is return)
  2. blow air into the hose to put pressure into your fuel tank.

How do you use starting fluid?

How do I use starting fluid? To use it on your engine, just spray a small amount into the air intake. To do this, you’ll have to remove your air filter and spray for about two or three seconds into the intake behind it. Make sure you replace the air filter and its cover before turning the key again.

Can you spray starter fluid into spark plug hole?

Adding starting fluid to the engine can be done by spraying it into the intake near the air filter or into the bore of the engine’s spark plug.

Why won’t my jet ski start in the water?

Why your jet ski won’t start can be a bad or weak battery, bad starter relay, bad starter motor, or you sucked something up. … If you’ve put a new battery in your jet ski and it still won’t start then it could be that the new battery is dead and needs to be load tested.

IT IS IMPORTANT:  How much does a Perception kayak weigh?

Does a jet ski need water to start?

You can start any jet skis out of the water, but just for a short time! If you attach a garden hose to their flush port to cool the engine with running water, the best practice is if you run the engine for around 2 minutes. But without supplying water, it’s safest if you run it for a maximum of 15 seconds!