Question: How do you drain water from a jet ski?

How do you get water out of a Seadoo?

One of the easiest ways to get rid of minimal, nuisance water is to simply ride your watercraft. A Sea-Doo’s onboard bailer system uses the natural suction of the jet pump to pull water out from inside the hull, emptying the hull of water as you ride.

How do you get water out of a jet ski?

The easiest way to get unwanted water out of your PWC hull is to drain it through the use of the craft’s existing drain plugs, tilting the nose to allow gravity to assist the process, and then manually drying excess water with a vacuum and sponge.

What can cause a jet ski to sink?

There are a couple of reasons as to why a jet ski would take on water, which includes missing or damaged drain plugs, a variety of damaged seals, improper maintenance, or inappropriate use of the jet ski itself.

How do you drain a Seadoo footwell?

The easiest way to remove water from the footwells on a jet ski by tilting the trailer up. If you can’t remove it all the water out this way, you can get the rest out with a big sponge, towel or a shop vac.

What do you do if you get water in a jet ski engine?

If the engine starts and dies, remove the spark plugs, blow the water off of them, install them and try again and again, until it starts. This usually takes about six times. After the engine starts and runs, either install a flush line or ride it at the lake for ten minutes. This will dry the engine, completely.

IT IS IMPORTANT:  Is Cancun good for scuba diving?