How do you rig a jib sail?

What part of the sail do you attach first when rigging the jib?

First, spread out the sail and identify each of its corners. The “head” is the top of the sail, where the triangle is the most narrow. Attach the jib halyard shackle to this corner, making sure the shackle is closed and secure. Then follow the front edge of the sail (called the “luff”) down to the next corner.

How long should my jib sheets be?

The rule of thumb with jib sheets is 1.5 times the boat length. Jib sheet length is governed by the lazy sheet, which needs to be long enough to reach the lazy winch with slack, and have a bit to spare.

What are Hanks on a sail?

Piston hanks and jib hanks are used for sail attachment. Traditionally, hanks consist of a short piece of rope spliced or sewn into or around the bolt rope, but can also be made of wire. … being able to attach and detach the sail from the stay quickly and easily.

What is a self tacking jib?

Self-tacking jibs are increasingly popular on new-build yachts. They make a boat very easy to sail upwind, with minimal effort and action required! … Basically, the sheet from the jib is led to a car which moves across the boat when the boat tacks-very much like a mainsheet traveler.

IT IS IMPORTANT:  What name is given to a sail in the shape of a truncated triangle?

How do you rig a jib halyard?

Slack the jib halyard (check for figure-8 knot, then uncleat and leave loose). Climb onto the foredeck and reach the jib halyard from the spinnaker ring. Attach the jib halyard to the jib-head eye. Lightly re-tension the halyard and cleat it (enough to keep halyard from fouling).

What step comes first when rigging the mainsail?

Describe how to rig a mainsail in five steps or more.

  1. Feed the foot into the groove in the boom, clew corner first.
  2. Unroll the sail and check for battens.
  3. Attach the tack, then the clew, and finish with the head.
  4. Loosen the mainsheet and boomvang.

How do you use a jib?

The jib is supposed to be pulled in on the same side of the boat as the mainsail, the leeward side. If the boat is on a starboard tack (wind is crossing the starboard side of the boat first), the mainsail will be on the port side. Thus, the jib should also be on the port side.

How do you heave to self tacking jib?


  1. Tether the jib clew to a weather fitting. …
  2. Roll away the jib, hoist a storm jib with two sheets; heave-to as traditional.
  3. Roll away the jib, lift the mainsheet car to weather and sheet in flat, adjust rudder to compensate. ( …
  4. Rig twin jib sheets when needed for heaving-to.